|
You will need...
-A bucket (or another item like a sink ror jug, as long as its bigger than the bottle)
-Bottle
-Scissors
-Tin foil
-Pin
First things first...
Ok, take your bottle and cut above the bobbly bits near the bottom, so that you have a flat base, now make a screen(gauze) by getting some tin foil and puttin it over the open bottle, then once that is fitted on nicely, poke holes in it to allow smoke to travel through to the bottle. using a pin, badge or anything like that to make the holes.
|
|
Now to use...
Building a bucket is simple, and using one is aswell, aslong as your careful. It might be a good idea to use a couple fo ppl if its your first bucket. Fill up the bucket with water and place the bottle in the water so it goes to the top of the bottle,make sure the gauze is above water level obviously, now being very careful, put the dope on the gauze and burn it, as you do this gently begin to pull the bottle upwards out of the water, keep pulling it upwards until the bottle is just under water level- watever you do DO NOT BRING THE BOTTLE UP ABOVE WATER LEVEL cos if you do, youre fucked and all youre smoke will escape. now once the chamber is full of creamy smoke, remove the gauze and push the bottle back into the water as you do this all the smoke will go into your lungs. enjoy!
|
|
|
